Applicable to SunDAT Pro

Question:

Is there a way to identify equipment like combiners and inverter enclosures after completing DC electrical?


Solution:

Labels for combiners and inverter enclosures can be turned and be visible in your SunDAT model.


Add Labels:

  1. Go to DC Electrical panel and then the Design Hierarchies tab.  
  2. At the top of each electrical hierarchy, which is the region name, click the Wrench tool.  Select Add/Refresh Labels
  3. Labels will now be placed where your equipment are located.
  4. If you make any edits, to the DC Electrical design, you can go back to the Design Hierarchies and then select the Wrench tool again and press Add/Refresh Labels.


Remove Labels:

  1. Go to DC Electrical panel and then the Design Hierarchies tab.  
  2. At the top of each electrical hierarchy, which is the region name, click the Wrench tool.  Select Remove Labels.  This will remove the labels for that region in your SunDAT Model.